Products

A flat square trowel for laying tile adhesive to an even bed. The steel blade holds its edge against abrasive mortars, and an even bed is what stops lippage and hollow spots under the tile.The swan neck hooks over the bucket rim between loads...

A protective mat for working over finished surfaces. Lay it across floors, benchtops, and cabinetry while the job runs, and spills, scuffs, and dropped tools mark the mat instead of the client's house.Light enough to reposition as the work moves, tough enough to reuse...

A stainless square notch trowel for tile adhesive beds, in notch sizes from 4mm to 15mm. Pick the size the adhesive datasheet calls: the notch sets how much adhesive goes down, and coverage is where bond failures start.Stainless shrugs off cement mortars and will...

A 300mm sponge for washing grout haze off tile and slate. The oversized face covers large-format work quickly, and the dense synthetic holds just enough water: wet enough to clean the joint, not so wet it washes the grout back out.It resists shredding on...

A chalk line for setting datum lines on floors and walls before tiling or laying out work. Snap a line where the grid starts and every tile or panel keys off one mark instead of drifting a few millimetres a row.The aluminium case takes...

Chalk refill for the BAT Trim chalk line. Pour it in, shake to settle, and get back to snapping straight lines for tile layout, stud work, or slab setout.Fine chalk gives a crisp line that does not blow away on concrete; keep the bottle...

The spare paddle for the BAT Pro 1600W electric mixer. The 140mm head moves more material per turn than the small paddle, matching what the bigger motor can push.M14 thread for hand-tight swaps, 590mm shaft for deep buckets.

Tile crosses set the grout gap between wall tiles. Push one into each junction as you lay, and every line comes out the same width. When the adhesive has set, either tap them in and grout over, or pull them out and fill the...

Tile wedges adjust spacing where a cross will not fit. The taper runs from 5mm down to a fine point, so you slide one under a tile edge to lift it level or nudge two tiles apart to widen a joint. Pull them out...

For sealing expansion joints, roof cladding, and window or door perimeters against weather, Biyseal Acrylic Impregnated Foam provides a highly compressible barrier that adapts to continuous joint movement. This high-density polyurethane foam is impregnated with an acrylic solution, allowing it to expand and contract...

For sealing metal cladding, expansion joints, roof valleys, and building penetrations against weather, dust, and vermin, Biyseal Bitumen Impregnated Foam provides a compressible, pre-formed barrier that expands and contracts without losing its recovery properties. Impregnated with bitumen, this flexible polyurethane strip exerts continuous outward...

Black Ace Disposable Nitrile Gloves are heavy-duty PPE designed for automotive and hydraulic technicians handling corrosive lubricants and sharp metal components. These 5-mil thick gloves feature low sweat technology and a textured surface to maintain tool control while preventing dermal absorption of hazardous fluids....

A replacement plunger for Adheseal professional and trade sausage guns. The moulded face seals tight against the foil pack, so nothing bypasses the piston and the extrusion rate stays even from the first bead to the last.The blue colour marks it as the spare,...

Husky 130 All Weather Tape is a clear UV-stabilised polyethylene tape for joining and repairing polyethylene sheeting, greenhouse and tunnel-house repairs, exterior patching, piping overwrap, electrical binding and general sealing. Adheseal stocks 8 mm × 50 m and 15 mm × 50 m rolls.Husky...

Bostik 6S Neutral Cure Silicone is a premium sanitary and tile silicone sealant for bathrooms, kitchens, laundries, shower screens and wet-area tiling. It contains mould and mildew inhibitors, cures with low odour and forms a flexible waterproof seal around tiles, sanitary ware, glass and...

For joints in insitu concrete, precast panels, blockwork, plasterboard, and fiber cement sheet requiring fire or acoustic certification, Bostik Fireban One Polyurethane Sealant provides up to a 4-hour fire rating under AS 1530.4-2014 and AS 4072.1-2005. This Australian-made, one-part intumescent sealant cures to form...

For expansion joints in precast and tilt-up panels, brickwork, concrete, and fibre cement sheet, Seal 'N' Flex One P390 Polyurethane Sealant 300ml provides a Class-A joint seal that accommodates high-movement thermal cycles. It cures to a tough, flexible barrier that handles constant contraction and...

For expansion joints in precast panels, tilt-up concrete, brickwork, and fibre cement sheet cladding, Seal 'N' Flex One P390 Polyurethane Sealant 600ml provides a highly flexible, low-modulus barrier that accommodates joint movement without pulling away from the substrate. It is acoustic rated and meets...

For expansion and construction joints in precast panels, concrete cladding, and window installations where joint movement causes standard sealants to shear or pull away, Seal ‘N’ Flex One Plus P590 Polyurethane Sealant 300ml provides a low-modulus, high-movement barrier. This polyurethane formulation cures bubble-free—even on...

For sealing expansion and construction joints in precast panels, insitu concrete, brickwork, and metal cladding, Bostik Seal ‘N’ Flex One Plus P590 provides a low-modulus polyurethane seal that accommodates joint movement without tearing or pulling away from the substrate. Joint movement and elasticity This...

For direct-stick timber flooring installations where boards must remain flat and bonded to concrete slabs without the risk of adhesive re-emulsification from moisture, Bostik Ultraset SF is a solvent-free polyurethane adhesive. It meets the requirements of EN 14293:2006 for bonding parquet to subfloors and...

Brass Clearout Spanner is ART Australia's purpose-made service tool for compatible floor-waste clearout fittings. It provides a dedicated way to engage and remove a clearout plug without improvising with tools that can damage the fitting. Best for Servicing compatible ART floor-waste clearouts. Maintenance work...

A brass injection packer for high-pressure epoxy and PU crack injection. The non-return valve shuts the moment you disconnect, so the crack stays full of resin instead of backing it out over the wall.Solid brass body stands up to pressure and site treatment, and...

Buzon DPH-0 is a fixed 17 mm pedestal for raised paver floors. Use it on terraces, balconies, and roofs where the available height is limited. It leaves a drainage void below the pavers.DPH-0 is part of the DPH raised-floor system for external pedestrian areas....

Buzon DPH-02 is an adjustable pedestal for raised paver floors from 25 mm to 36 mm. Use it on terraces, balconies, and roofs where the available height is limited. It leaves a drainage void below the finish.DPH-02 is part of the DPH raised-floor system...

Buzon DPH-1 is an adjustable pedestal for raised paver floors from 18 mm to 28 mm. Use it on terraces, balconies, and roofs where the available height is limited. It leaves a drainage void below the finish.DPH-1 is part of the DPH raised-floor system...

Buzon DPH-2 is an adjustable pedestal for raised paver floors from 35 mm to 53 mm. Use it on terraces, balconies, and roofs. It leaves a drainage void below the finish.DPH-2 is part of the DPH raised-floor system for external pedestrian areas. Do not...

Buzon DPH-3 is an adjustable pedestal for raised paver floors from 50 mm to 78 mm. Use it on terraces, balconies, and roofs. It leaves a drainage void below the finish.DPH-3 is part of the DPH raised-floor system for external pedestrian areas. Do not...

Buzon DPH-4 is an adjustable pedestal for raised paver floors from 77 mm to 108 mm. Use it on terraces, balconies, and roofs. It leaves a drainage void below the finish.DPH-4 has an integrated slope corrector for 0% to 5% falls. It is for...

Buzon DPH-5 is an adjustable pedestal for raised paver floors from 100 mm to 175 mm. Use it on terraces, balconies, and roofs. It leaves a drainage void below the finish.DPH-5 has an integrated slope corrector for 0% to 5% falls. It is for...

Buzon DPH-5 Coupler for Pedestal Extension is a modular height-adjustment component for professional raised access flooring in high-clearance rooftop and terrace environments. This heavy-duty coupler allows installers to bridge deep structural voids and MEP service runs by extending the pedestal range up to 1070mm...

Buzon Joist Holder DPH-KIT-5 is a technical joist management component designed for the secure installation of timber and composite terraces on DPH and PB-0-S18 pedestal systems. Manufactured from 80% recycled copolymer polypropylene, this press-fit holder prevents structural instability by accommodating joists up to 90mm...

Buzon PB-KIT-5 fixes timber or composite deck joists to Buzon PB pedestals. It takes joists up to 100 mm wide and helps you build a raised external deck at the required height.Fit it only to a compatible PB pedestal and joist. It is for...

Buzon PB Spacer Tabs fit PB pedestal heads to set an even gap between pavers. Use them on raised paver floors where open joints allow water to drain.The tabs are 17 mm high and come in 2 mm, 3 mm, 4.5 mm, 6 mm,...

Buzon PB-0-S12 Adjustable Pedestal (12-18mm) is an ultra-low profile raised flooring support engineered from Copolymer Polypropylene (CPP) for balconies and rooftop terraces. It provides a non-penetrative leveling solution that protects the underlying waterproof membrane from mechanical punctures while facilitating rapid water runoff and evaporation...

Buzon PB-0-S18 Adjustable Pedestal (18-28mm) is a specialized support system for achieving precise levels in ultra-low clearance zones on rooftop terraces and balconies. Engineered from weather-proof copolymer polypropylene (CPP), this pedestal provides an industrial-strength 27.30 kN breaking load that eliminates floor bounce and supports...

Buzon PB-01 is an adjustable pedestal for raised paver floors or timber and composite decks from 28 mm to 42 mm. Use it on balconies, terraces, and roofs where a low build-up is needed. It leaves a void below the finish for drainage and...

Buzon PB-1 is an adjustable pedestal for raised paver floors or timber and composite decks from 42 mm to 60 mm. Use it on balconies, terraces, and roofs. It leaves a void below the finish for drainage and services.Use PB Spacer Tabs for pavers....

Buzon PB-10 is an adjustable pedestal for raised paver floors or timber and composite decks from 675 mm to 830 mm. Use it on balconies, terraces, and roofs. It leaves a void below the finish for drainage and services.Use PB Spacer Tabs for pavers....

Buzon PB-11 is an adjustable pedestal for raised paver floors or timber and composite decks from 755 mm to 955 mm. Use it on balconies, terraces, and roofs. It leaves a void below the finish for drainage and services.Use PB Spacer Tabs for pavers....

Buzon PB-2 is an adjustable pedestal for raised paver floors from 60 mm to 90 mm. Use it for ceramic or stone pavers on balconies, terraces, and roofs. It leaves a void below the finish for drainage.Use PB Spacer Tabs to set the paver...

Buzon PB-3 is an adjustable pedestal for timber or composite deck joists from 90 mm to 145 mm. Use it for raised external decks on balconies, terraces, and roofs. It leaves a void for drainage and services.Use PB-KIT-5 to fix a compatible joist to...

Buzon PB-4 is an adjustable pedestal for raised paver floors or timber and composite decks from 145 mm to 245 mm. Use it on balconies, terraces, and roofs. It leaves a void below the finish for drainage and services.Use PB Spacer Tabs for pavers....

Buzon PB-5 is an adjustable pedestal for raised paver floors or timber and composite decks from 235 mm to 315 mm. Use it on balconies, terraces, and roofs. It leaves a void below the finish for drainage and services.Use PB Spacer Tabs for pavers....

Buzon PB-6 is an adjustable pedestal for raised paver floors or timber and composite decks from 285 mm to 367 mm. Use it on balconies, terraces, and roofs. It leaves a void below the finish for drainage and services.Use PB Spacer Tabs for pavers....

Buzon PB-7 is an adjustable pedestal for raised paver floors or timber and composite decks from 365 mm to 480 mm. Use it on balconies, terraces, and roofs. It leaves a void below the finish for drainage and services.Use PB Spacer Tabs for pavers....

Buzon PB-8 is an adjustable pedestal for raised paver floors or timber and composite decks from 480 mm to 595 mm. Use it on balconies, terraces, and roofs. It leaves a void below the finish for drainage and services.Use PB Spacer Tabs for pavers....

Buzon PB-9 is an adjustable pedestal for raised paver floors or timber and composite decks from 560 mm to 715 mm. Use it on balconies, terraces, and roofs. It leaves a void below the finish for drainage and services.Use PB Spacer Tabs for pavers....

Buzon PB-C1 Coupler (Extender) is an industrial-grade vertical extension component for the PB-5 to PB-11 pedestal range in professional raised flooring applications. Engineered from Copolymer Polypropylene (CPP), it delivers 85mm to 120mm of height adjustment per unit with high resistance to sea salts and...

Buzon PB-C2 Coupler (Extender) is a high-clearance structural component for the PB pedestal series, engineered to provide vertical extension in professional raised flooring applications. Each unit provides a 195mm to 235mm height boost, using chemical-resistant Copolymer Polypropylene (CPP) to ensure long-term stability in coastal...