100mm Round Megaflex Stick Down Floor Waste

Why Choose 100mm Round Megaflex Stick Down Floor Waste

Use 100mm Round Megaflex Stick Down Floor Waste for high-flow wet-area drainage where a low-profile, bondable outlet must integrate reliably with membrane systems and tiled substrates.

100mm Round Megaflex Stick Down Floor Waste Common Uses

This component is selected when a 100mm wide-bore outlet is required to handle large wet-area flows and to provide a secure, bonded interface for waterproofing membranes in slab and screed applications.

• Large wet areas such as bathrooms and commercial wet rooms where high-capacity drainage is essential.
• Tile and screed floors where the ABS Megaflex™ flange enables a bonded, leak-guarding seal to membranes.
• Shallow floor cavities or tight slab conditions where a low-profile, stick-down configuration is required.

Where 100mm Round Megaflex Stick Down Floor Waste Performs Best

Performs reliably on non-porous, dimensionally stable substrates compatible with ABS plastic bonding, in temperate environments within the specified temperature range and where membrane integrity can be maintained.

Coverage, Skin Time & Cure

Yield and coverage are governed by the 100mm wide-bore high-flow design, allowing efficient drainage while maintaining a compact, low-profile installation that suits shallow slab profiles.

• Cement screed substrate: requires bonding primer for secure adhesion prior to fixture installation.
• Skin time: determined by tradesite conditions; ensure fixture positioning before material set.
• Cure: allow full bond development in accordance with membrane and slab cure schedules; avoid thermal or mechanical disturbance during initial set.

Surface Prep & Application

Prepare a sound, clean substrate free of contaminants and ensure the membrane system is properly detailed; position the low-profile flange below the tile line to maintain surface integrity and drainage function.

1. Clean and prime the substrate as required, especially for cement screed, to ensure robust bonding.
2. Install the fixture ensuring the ABS Megaflex™ flange seats securely and is recessed correctly below the tile line.
3. Verify membrane continuity at the flange perimeter, applying appropriate sealing protocols to prevent lateral water bypass.
4. Confirm 100mm pipe alignment to avoid stress on the outlet and maintain hydraulic performance.

Best Practices for Using 100mm Round Megaflex Stick Down Floor Waste

Integrate the fixture with compatible waterproofing membranes and select complementary materials that preserve the AS/NZS 3500 WaterMark certified performance under expected site conditions.

• Use a bonding primer on cement screed to achieve durable adhesion.
• Ensure the ABS Megaflex™ flange is fully seated and compressed to maintain leak-guarding membrane continuity.
• Avoid exposure to temperatures above 60°C or storage outside 5°C–25°C to protect material integrity.
• Confirm substrate compatibility with ABS plastic bonding to prevent delamination.
• Validate that pipe and outlet alignment allow unobstructed flow from high-capacity fixtures.

Handling & Storage

Handle with standard site PPE in well-ventilated conditions; store in a dry area protected from UV exposure within the recommended temperature range to preserve dimensional stability and membrane bonding performance.

• PPE: use site-appropriate gloves and eye protection during handling.
• Ventilation: maintain adequate airflow in enclosed storage or cutting areas.
• Storage temperature: keep between 5°C and 25°C in a dry environment.
• UV protection: shield from prolonged exposure to direct sunlight.
• Disposal: follow local regulations for non-hazardous plastic waste.